Battery Installation; Battery Charging - VTech DS6101 User Manual

Getting started

Battery installation

Install the battery as shown below.
1 Plug the battery connector
securely into the socket inside the
battery compartment, matching
the color-coded label.
3 Slide the battery compartment
cover towards the center of the
handset until it clicks into place.

Battery charging

Once you have installed the battery, the screen indicates the battery status
(see the table below).
• For best performance, keep the handset in the telephone base or
charger when not in use.
• The battery is fully charged after 16 hours of continuous charging.
• If the handset will not be used for a long time, disconnect and
remove the battery to prevent any possible leakage.
Battery indicators
The screen is blank.
The screen shows
Place handset in
charger and
flashes.
The screen shows Low
battery and
flashes.
The screen shows
HANDSET.
Battery status
Battery has no charge and
the handset cannot be used.
Battery has very little charge
and the handset cannot be
used.
Battery has enough charge
to be used for a short time.
Battery is charged.
2
2 Place the battery with the label
THIS SIDE UP and the wires
inside the battery compartment.
4 Charge the handset by placing it
in the telephone base.
CHARGE light remains
on when charging.
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone
base when not in use.