Add And Register A Handset - VTech Accessory Handset for use with the CS6319 CS6329 or CS6328 User Manual

Getting started

Add and register a handset

Each newly purchased handset (CS6309) must be registered
to the telephone base before use. When first purchased,
each handset shows 1.PreSS FIND hS ON BASe 4 SeC
and 2.TheN PreSS # ON hANDSeT alternately. You
may need to charge the handset before registering to the
telephone base. For more details on battery charging, see
page 3.
To make registration easier, read all the instructions on this
page before you begin.
To register a handset:
1. Place the unregistered handset in the
telephone base. If 1.PreSS FIND hS
ON BASe 4 SeC and 2.TheN PreSS #
ON hANDSeT do not appear alternately
on the handset screen after a few
seconds, remove the handset and place it
in the telephone base or charger again.
2. On the telephone base, press and hold
/FIND hANDSeT for about four seconds
(until the red IN USe light on the
telephone base turns on) and then
release the button.
3. Remove the handset from the telephone
base or charger. Press # and the handset
displays reGISTerING...PLeASe WAIT. It takes about
10 seconds to complete the registration. The handset
shows hANDSeT reGISTereD and you hear a beep
when the registration completes.
When the registration is complete, the newly registered
handset is assigned the next available handset registration
number. For instance, if you already have hANDSeT 1, the
next registered handset will be hANDSeT 2.
If the registration fails, the handset shows 1.PreSS FIND
•
hS ON BASe 4 SeC and 2.TheN PreSS # ON hANDSeT
alternately. To reset the handset, remove the handset from
the telephone base and place it back in. Try the registration
process again.
• You cannot register a handset if any other system handset
is in use.
• Only one handset set can be registered at a time.
4