Battery installation
Install the battery as shown below.
.
Plug the battery connector
securely into the socket.
3.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
•
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
•
To purchase a replacement battery, visit our website at www.vtechphones.com
or call (800) 595-95 . In Canada, go to www.vtechcanada.com or dial
(800) 67-7377.
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the following table).
•
For best performance, keep the handset in the telephone base or
handset charger when not in use.
•
The battery is fully charged after hours of continuous charging.
•
If you place the handset in the telephone base or handset charger
without installing a battery, the screen displays
Battery indicators
The screen is blank, or
shows Put in charger and
flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
When it is fully charged, you can expect the following performance:
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
Battery status
The battery has no charge
or very little charge. The
handset cannot be used.
The battery has enough
charge to be used for a
short time.
The battery is charged.
Operation
.
Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
.
Place the handset in the telephone
base or charger to charge.
CHARGE light
remains on
when charging.
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Up to seven hours
Up to three hours
Up to five days
.
NO BATTERY
Action
Operating time
Need help?
Do you have a question about the DS6501 and is the answer not in the manual?
Questions and answers