Cloud Software; Fleet Management And Status - ExRobotics ExR-1 Operating Manual

It's best not to switch off the robot (using the black On/Off switch) when the robot is in the
docking station since this can disrupt charging. If this happens pull the robot 30cm back and
switch it off and on again.
When a driver checks the "Keep Awake" setting the robot video streams will typically appear
within 1 minute. The robot is then ready to use although it's best to allow gas sensors 30
minutes to warm up before starting a mission.
When starting a mission and reversing away from the docking station, the driver should
carefully examine the back camera or the mirror on the front of the docking station (if fitted) to
ensure there are no obstructions.
A power socket (when fitted) enables the robot to be charged within 3 hours. This requires the
robot to be manually plugged into a power supply using a quick-charger that can be ordered
with the robot. The quick-charger's lead is typically 3 meters long. If the robot is docked you
should first switch off power to the induction charger. When inserting the quick-charge plug,
rotate the entire body clockwise before tightening the ring around its base. You can check the
status of the charging using the LEDs and instructions on the quick charger.
5.

Cloud Software

Robots are operated and data is collected using the "cloud". Access is granted as described in
Section 7.2. Five types of screens are available as described below.
5.1.

Fleet Management and Status

Fleet Management is the first screen that appears when users log on. It allows them to connect
to any robot to which they've been granted access. Scrolling down reveals more robots.
ExRobotics B.V.
ExR-1 Robot
Operating Guide
This document is considered an uncontrolled copy when printed. Always ensure that you print and use a current version.
Copyright 2020 ExRobotics B.V.
Document No.: Owner:
20190122IP1
Version No.: 11 Ian Peerless
Date:
2020-03-31 Page 6 of 23