EGO ZT5200L Operator's Manual page 58

CALIBRATE THE LAP BARS
If the mower is not tracking straight, first check the air pressure
in both rear wheel tires. If the tire pressures are set to the
recommendation in section "CHECKING THE TIRE PRESSURE" in
this manual, calibrate the lap bars as follows:
1. Insert the battery packs into the battery compartments of the
power unit.
2. Set the parking-brake pedal in the braking position.
3. Press the start/stop button briefly and the LCD screen will
show the "Fuel Gauge" (Fig. 48).
4. Press and hold the driving-mode button and the set button
simultaneously for more than 3 seconds to enter the
calibration interface. The audio indicator will sound once
and the LCD screen will show the calibration bar with the
calibration indicator in the center position (Fig. 49).
5. If the mower is tracking to the left, the right wheel of the
mower should be calibrated by briefly pressing the driving-
speed-adjustment button " ". When pressed one time, the
calibration indicator will move to the right one grid from the
center position and continue flashing (Fig. 50).
6. If the mower is tracking to the right, the left wheel of the
mower should be calibrated by briefly pressing the driving-
speed- adjustment button " ". When pressed one time, the
calibration indicator will move to the left one grid from the
center position and continue flashing.
7. When the calibration is finished, press the set button to
save and quit the calibration interface. The audio indicator
will sound once to indicate that the calibration is saved
successfully. Restart the mower to check whether the mower
can drive straight. Otherwise, repeat the above steps until the
mower is tracking straight.
RESETTING THE MOWER TO INITIAL FACTORY SETTING
1. Insert the battery packs into the battery compartments of the
power unit.
2. Set the parking-brake pedal in the braking position.
3. Press the start/stop button briefly and the LCD screen will
show the "Fuel Gauge" (see Fig. 48).
4. Press and hold the LED light button and set button
simultaneously for more than 5 seconds, the audio indicator
will sound once as a reminder and the mower status indicator
over the LCD screen will flash ORANGE. Resetting is successful.
58
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT5200L/ZT5200L-FC
48
Driving Mode Button
49
Calibration
Indicator in
the Center
Position
50
Center
Position
Set Button
Calibration Bar
Calibration Bar
Calibration
Indicator