Labconco Protector 3930000 User Manual page 11

Chapter 3:
Getting Started
Now that the site for your Protector Work Station is properly prepared, you
are ready to unpack, inspect, install, and validate your system. Read this
chapter to learn how to:
 Unpack and move the enclosure.
 Set up the enclosure with the proper supporting structure and work
surface.
 Connect to an exhaust system (only applicable for remote blower).
 Installation of carbon filters (only applicable for integral blower
exhausted to the room).
 Connect the electrical supply.
 Set the face velocity with the speed control adjustment, only
applicable for integral blower.
 Arrange validation for the enclosure.
 Seal the enclosure to the work surface.
Depending upon which model you are installing, you may need common
mechanical and electrical installation tools in addition to wrenches,
ratchets, sockets, a nut driver set, a flat-blade screwdriver, a Phillips
screwdriver, and a carpenter level to complete the instructions in this
chapter.
Each enclosure weighs either 85 or 105 lbs. each (37 or
!
46 kg). The shipping container allows for lifting with a
mechanical lift truck or floor jack. If you must lift the
enclosure manually, follow safe-lifting guidelines.
not lift by the front air foil
Product Service 1-800-522-7658
.
Do
7