Whirlpool 1188018 Use And Care Manual page 11

Install Wood Frame
1. Construct wood frame. See "Location Requirements" for
dimensions.
2. Measure outside width and height of frame to determine wall
opening dimensions.
3. Cut opening through the wall. Remove and save insulation.
NOTES:
Dimension for depth depends on wall thickness and type
of molding.
Do not block louvers in air conditioner cabinet.
Use 1" (2.5 cm) or thicker lumber for wood frame.
A. Outside width
B. Outside height
C. Depth
4. Apply wood preservative to the outside exposed surface.
5. Insert the frame in the wall opening. Square and level frame.
6. Attach frame securely to the wall.
7. Place a " (2 cm) thick by 2" (5 cm) wide wood strip on the
bottom of the opening against the inside edge.
D
A. 17 " (43.8 cm)
B. 2" (5 cm) wide
8. Center the tray back in the opening and align it with the inside
edge of the opening. Using the 2 inside screw holes in the
tray back, mark screw locations for mounting the
SMART-MOUNT ® tray.
A. Flush with inside wall
A
B
C
A
C
B
C. " (2 cm) thick
D. Indoor side of wall opening
A
A
A. Inside screw holes
B. Indoor side of wall opening
9. Remove the tray back. Using these marks, drill
approximately 1 " (3.8 cm) deep.
Assemble SMART-MOUNT
1. To assemble the tray frame, insert tab on tray back into slot
on tray side. Check to see that the tab is engaged and the
2 pieces are aligned. Insert 2 - #8 - 18 x
to secure.
2. Repeat with other tray side.
B
A
A. Tray back
B. #8 - 18 x
C. Tray side
B
" pilot holes
® Tray
" hex-head screws
C
" hex-head screws
11