Attach Support Legs
1. Determine the correct slots on the tray side from the type of
exterior construction of the building.
Thin Wall Construction (vinyl, wood, etc.)
A. First and second slots
Thick Wall Construction (brick)
A
A. Second and third slots
2. Insert carriage bolt up through slot on tray-frame side and
support leg.
3. Place one end of tray center over carriage bolt.
12
A
4. Then place flat washer, lock washer and hex nut.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
A. Hex nut
B. Lock washer
C. Flat washer
5. Insert second carriage bolt through tray side and attach other
end of support leg.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
A. Hex nut
B. Lock washer
6. Install support leg on other side.
Install SMART-MOUNT
1. From inside, place SMART-MOUNT
down, in the wall opening. Match the holes in tray side with
the predrilled holes in wall opening.
A
B
C
D
E
D. Tray center
E. Carriage bolt
A
B
C
D
C. Flat washer
D. Carriage bolt
®
Tray Assembly in Wall Opening
®
tray, support legs facing