Advertisement
8241 Iox ib 2
21/05/2002
Quick start
1 Assemble the nozzle, tubes and hose as
A
shown
.
2 Pull out the cable to it's full length and plug
in to the mains supply.
3 Switch on by pressing the foot pedal
Accessories
1 Fit the hose to the cleaner by inserting the
hose end into the hose inlet
removing, squeeze the clips either side and
pull.
2 Attach the two tubes to the handle end of
the hose.
The hose handle features a regulator
which allows the suction to be reduced as
required B. Closed gives full suction, open
gives reduced suction.
3 Attach the wheeled floor nozzle
extension tubes.
The crevice tool (for awkward places,
behind radiators etc.) and the upholstery brush
(for curtains and upholstery) are stored inside
the cleaner under the cover
cover release buttons › to open the cover.
The crevice tool has a flip-action brush
attachment for hard surfaces, pelmets, delicate
objects etc.
4
6:19 PM
Page 4
fl
.
⁄
. When
·
fl
to the
C
. Squeeze the
B
Á
Controls
Power
The on/off control is operated by the foot
fl
pedal
.
Automatic cable rewind
After use, unplug and press the cable
rewind button ‡ to retract the cable.
WARNING: When using the cable
rewind, always hold the plug as the cable
will rewind quickly.
Dustbag condition
indicator
If the suction power decreases or if the
dustbag condition indicator
then the bag must be emptied immediately
and/or the motor protection filter cleaned, even
if the bag does not appear full. This will also
occur if the nozzle, tubes or hose have
become blocked.
• The dustbag indicator may occasionally
show red during use - this is quite normal.
Í
‹
shows fully red
C
Ê
Advertisement
