Table of Contents
Advertisement
orb cyclone 73171M REV 1
Quick start
1 Assemble the nozzle, telescopic tube
and hose as shown A.
2 Pull out the mains cable to it's full length
and plug into the mains supply.
3 Switch on by pressing the foot pedal ›.
Accessories
1 Fit the hose to the cleaner by inserting
the hose end into the hose inlet ⁄.
When removing, squeeze the clip and
pull.
2 Attach the telescopic tube to the handle
end of the hose. Extend to the required
length by pressing down the slider
release and pulling out the tube B.
The hose handle features an airflow
regulator  which allows suction to be
reduced as required.
3 Attach the wheeled floor nozzle Î to the
tube.
The crevice tool È is ideal for use in
awkward places, behind radiators etc and
the upholstery tool Í for curtains and
upholstery. C
Both these tools are stored beneath the
lid.
30/7/04
11:36 AM
Controls
Power
Variable power
required. For example, maximum suction
can be used for cleaning carpets, hard
floors etc. and reduced suction for cleaning
upholstery and curtains.
airflow regulator on the handle Â. Closed
for maximum suction, open for reduced
suction.
Automatic cable rewind
B
rewind button ¤ to retract the cable.
rewind, always hold the plug as the cable
will rewind quickly.
Using the turbo nozzle
for use on upholstery and stairs.
Cleaning the turbo nozzle
cleaned and any hairs or fibres wrapped
around the brush bar removed to maintain
optimum performance. To aid cleaning, the
turbo nozzle can be opened up by pushing
È
C
the button on the nozzle forwards.
Í
4
Page 4
The on/off control is operated by the foot
pedal ›.
A dial fi varies the suction power as
Suction can also be controlled using the
After use, unplug and press the cable
WARNING: When using the cable
Attach the turbo nozzle to the hose end
The turbo nozzle should be regularly
Advertisement
Table of Contents
