Table of Contents
Advertisement
Quick start
1 Assemble the nozzle, telescopic tubes and
A
hose as shown
2 Pull out the mains cable to it's full length
and plug in to the mains supply.
3 Switch on by pressing the foot pedal
Accessories
1 Fit the hose to the cleaner by inserting the
hose end into the hose inlet
removing, squeeze the clips either side and
pull.
2 Attach the telescopic tubes to the handle
end of the hose. Extend to the required
length by pressing down the slider release
Ê and pulling out the tube B.
The hose handle features a regulator
which allows the suction to be reduced as
required.
3 Attach the combination floor nozzle
the tubes.
The crevice tool (for awkward places,
behind radiators etc.) and the upholstery brush
(for curtains and upholstery) are stored on the
tubes. The crevice tool has a flip-action brush
attachment for hard surfaces, pelmets, delicate
objects etc C.
Ê
.
⁄
. When
È
Â
Controls
Power
The on/off control is operated by the foot
fi
fi
.
pedal
Variable power control
A rotating dial
as required. For example, maximum suction
can be used for cleaning carpets, hard floors
etc. and reduced suction for cleaning
upholstery and curtains.
Suction can also be controlled using the
airflow control on the handle
maximum suction, open for reduced suction.
Automatic cable rewind
After use, unplug and press the cable
rewind button › to retract the cable.
to
WARNING: When using the cable
rewind, always hold the plug as the cable
will rewind quickly.
B
.
‡
varies the suction power
Á
È
. Closed for
C
Advertisement
Table of Contents
