Quick Start - Morphy Richards IB71053 Instructions Manual

71053 Rev 2 11/4/05

Quick start

1 Assemble the nozzle, telescopic tube
and hose as shown A.
2 Pull out the mains cable to it's full length
and plug into the mains supply.
3 Switch on by pressing the foot pedal ›.
Accessories
1 Fit the hose to the cleaner by inserting
the hose end into the hose inlet ⁄.
When removing, squeeze the clips either
side and pull.
2 Attach the telescopic tube to the handle
end of the hose. Extend to the required
length by pressing down the slider
release and pulling out the tube B.
The hose handle features an airflow
regulator  which allows suction to be
reduced as required.
3 Attach the wheeled floor nozzle Ì to the
tube.
4 The floor nozzle can be adjusted to suit
different floor surfaces. Retract the
brushes for use on carpet. The brushes
must be down for use on hardfloors or
damage may occur.
The crevice tool Í (for awkward places,
behind radiators etc) and the upholstery
nozzle Î with clip on brush Ï (for curtains
and upholstery) are stored in the tool
drawer ‚. The crevice tool is used for hard
surfaces, pelmets, delicate objects etc C.
9:24 AM Page 4
B
4
Using the hard floor
brush
Designed specifically for use on wood,
tiles and all other hard floor types.
Attach to the telescopic tubes.
Stair cleaning hose
An additional stretch hose is also
provided for use on stairs. Fit the hose to
the cleaner by inserting the hose end into
the hose inlet. When removing squeeze the
clips either side and pull.
WARNING: For safety, always leave
the cleaner at the bottom of the stairs
and clean upwards.
Í
Î
Ó
C
Ï