KaVo DIAGNOcam Vision Full HD Quick Reference

Quick Reference -
DIAGNOcam Vision Full HD
DIAGNOcam Vision Full HD
Installation / Setup
Power on
Capture an image
Start / stop a video
Switch between modes
Navigation of tooth chart
Status LED
Power off
1
1
2
2 2
2
4
4
1
2
2
4
1
4
X For software installation and
start up note the instructions
for use and the installation
instructions of the software.
The camera can be switched on
by the following means:
• System start of the imaging
software
• Pressing any button on the
control panel
• Removal of the camera from
the table holder or wall mount
X Press the trigger button
capturing an image and/or for
starting/stopping the video
recording.
3
3 X To switch between the modes
(intraoral, fluorescence and
transillumination ), press the
menu button
3
1 2
X Press the buttons
gation in the numbered tooth
chart (if available in your soft-
ware).
Status LED indicating the sta-
1 2 3 4
tus of the camera:
• Withe = Camera is active
3
• Blue = Standby mode
• Red = Error
The camera can be switched off
by the following means:
• Placing the camera in the table
holder or wall mount
• Extended period of inactivity
for
1 3 4 5
2
.
6
4 5 7
for navi-
1 2 3 4 5 6 7
5 6 7
6