MADER POWER SF8A220 Manual page 56

TROUBLE SHOOTING
The following form lists the common operating system with problem and solutions.
Please read the form carefully and follow it.
PROBLEMS
Motor fails to start when
switch trigger is pressed.
Line will not feed.
Poor
performance.
POSSIBLE
CAUSES
Check battery
charger.
Check power
button.
Check spool.
Replace
spool.
cutting Check
cutting line.
SOLUTION
Recharge.
Push button.
1. Check line is not tangled or jammed in
the spool.
2. Remove the line and replace the spool
of the line and ensure the mechanism is
clean.
the 1. Check the cutting line is fully extended.
If not:
2. Manually extend the line or stop and
start the trimmer until the line has been
extended to the line cutter.
3.Make smaller cuts, this is a light duty
trimmer.
4.Ensure line is fully extended.
55