MADER POWER SF8A220 Manual page 50

C
ONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the string trimmer
for the first time, place the battery pack in the battery charger and charge. Make sure
to read all safety precautions, and follow the instructions in the battery charger
section.
To remove the battery pack
• Press the button (1) on the handle,
Slide the battery pack backward, and
then pull or lift the battery out of the
tool (see fig 8).
To install the battery (not included)
To install the battery pack into the tool, align the
rails of the battery pack with the rails in the tool
and push the battery into the housing. To connect
the battery, slide the battery pack fully forward.
Until the latch locks into place (see fig 9).
WARNING: Follow these instructions in order to avoid injury and to reduce the
risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or
charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or
performing maintenance on any part of the string trimmer.
• Read, understand, and follow the instructions.
C
ONNECTING CHARGER
Power supply(mains) voltage and operating
voltage must be the same.
• Insert the plug in the wall outlet.
• A self-test is performed after the
charger is connected to the power
supply. During this process, the green
light (1) on the charger lights up.
(N I )
OT NCLUDED TO POWER SUPPLY
Fig. 8
Fig. 9
49
1
1