Pairing, audio system
6
with communication
system in helmet 2
56
Switching on
communication system
in helmet 2
z
Press button 2 and hold it
down until a high-pitched con-
firmation tone sounds and
green LED 6 starts flashing.
The communication system
initialises itself; the green LED
slow-flashes.
The communication system
then goes to standby mode;
the green LED flashes as the
rate of one flash per second.
Deleting pairing entries in
communication system in
helmet 2
Simultaneously press button 1
and button 2 and hold the but-
tons down.
If deletion is successful, green
LED 6 lights up briefly and
then starts slow-flashing to in-
dicate that the system is on
standby. A high-pitched con-
firmation tone sounds.
Note time limit
The next two steps
Make the communication sys-
tem visible
Searching for communication
system
are subject to a time limit of 60
seconds.
Consequently, they must be per-
formed one directly after the oth-
er.
BMW Motorrad recommends
reading through the instructions
for both steps before proceeding.