Rotenso CONTROL SETU User Manual page 13

7.4.2. GEAR function:
Press the ECO/GEAR button to enter GEAR mode as follows:
In GEAR mode, the display of the remote control will alternately show the electricity consumption and the set
temperature.
7.5. Mute function (SIlence) (selected models)
2s
7.6. SMART 8°C heating function ( selected models)
SMART 8/12°C heating (selected models). This function constantly monitors the temperature inside the room
to prevent excessive cooling, the air conditioner will start automatically in heating mode. This maintains the
air temperature at 8/12°C (depending on the model).
2
To enable „FP12" mode, follow the instructions below (only available on selected models):
• Follow the instructions for starting FP8 mode
• Once we have FP8 mode running, press the down arrow twice and the display will show „12", this indicates
the correct activation of this function.
75% (up to 75% of electricity consumption)
50% (up to 50% electricity consumption)
Previous setting mode
Hold down the Fan button for more than 2 seconds to activate/deactivate the mute
function (some models).
Due to the low operating frequency of the compressor, the cooling and heating
capacity may not be su cient. Pressing the ON/OFF, Mode, Sleep, Turbo or Clean
button during mute operation will cancel the mute function.
To enable „FP8" mode, follow the instructions below (only available on selected
models):
• Run the air conditioner in heating mode (HEAT) and set to the lowest
possible temperature (usually this will be 16°C)
• Press the down arrow twice and the air conditioner display will show „8", this
indicates that the FP function has started correctly.
Remote control - Setu
User manual
EN
13