Rotenso CONTROL SETU User Manual page 12

Remote control - Setu
EN
Attention:
When the unit is switched o , press and hold the MODE and SWING buttons together for one second, the louvre will
open at a certain angle, making it very convenient to clean. Press and hold the MODE and SWING buttons together
for one second to reset the louver(Depending on the model).
7.3. LED display (selected models)
Press the LED button
Press this button to switch the display of the
indoor unit on or o .
7.4. ECO/GEAR function (selected models)
7.4.1. ECO operating mode:
In cooling mode, press this button, the remote control will automatically adjust the temperature to 24°C/75°F,
fan speed Auto to save energy (only when the set temperature is lower than 24°C/75°F). If the set temperature
is higher than 24°C/75°F, press the ECO button, then the fan speed will change to Auto and the set temperature
will remain unchanged.
Attention:
Pressing the ECO button or changing the mode or setting the temperature below 24°C/75°F will stop operation in ECO
mode. In ECO mode the set temperature should be 24°C/75°F or higher, this may result in insu cient cooling. When
uncomfortable, simply press the ECO button again to stop it.
12
User manual
LED
Press the GEAR-ECO button to switch to energy-saving mode in the following
order:
ECO GEAR(75%)
Note: This function is only available in COOL mode.
Press this button for more than 5 seconds
Press this button for more than 5 seconds, the indoor
unit will display the actual room temperature.
Pressing again for more than 5 seconds will return
to the display of the set temperature.
Previous setting mode
GEAR(50%)
5s
LED
ECO......