98
A d d i n g Par ts
To verify that the memory is installed correctly, check the amount of
12
memory (RAM) listed.
Adding or Replacing the AGP Card
CAUTION: Before you begin any of the procedures in this section,
follow the steps in "When Working Inside Your Computer" on
page 12.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
Your Dell™ computer provides a connector for an AGP card.
Shut down the computer (see page 33).
1
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Turn off any attached devices and disconnect them from their
2
electrical outlets.
Disconnect the computer power cable from the wall outlet, and then
3
press the power button to ground the system board.
Open the computer cover (see page 84).
4
Removing an AGP Card
Remove the filler bracket by raising the hinged lever and sliding the
1
bracket up.
Press the card lever toward the PCI connector.
2