Adding Or Replacing The Agp Card - Dell Dimension 4550 Series Owner's Manual

94
A d d i n g Par ts
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
5
them on.
Click the Start button, right-click My Computer, and then click
6
Properties.
Click the General tab.
7
To verify that the memory is installed correctly, check the amount of
8
memory (RAM) listed (see page 110).

Adding or Replacing the AGP Card

CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 9.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
Your Dell™ computer provides a connector for an AGP card.
Shut down the computer (see page 33).
1
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Turn off any attached devices and disconnect them from their
2
electrical outlets.
Disconnect the computer power cable from the wall outlet, and then
3
press the power button to ground the system board.
Open the computer cover (see page 83).
4