Adding A Second Hard Drive - Dell Dimension K0004 Owner's Manual

100
A d d i n g Par ts
Close the computer cover (see page 107).
4
Connect the monitor cable to the card's video connector.
5
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
6
them on.

Adding a Second Hard Drive

CAUTION: Before you begin any of the procedures in this section,
follow the steps in "When Working Inside Your Computer" on
page 12.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface.
Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
Check the documentation for the drive to verify that it is configured
1
for your computer.
Shut down the computer (page 33).
2
Turn off your computer and any devices.
3
Ground yourself by touching an unpainted metal surface on the
4
chassis, such as the metal around the card-slot openings at the back of
the computer, before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the
computer chassis to dissipate any static electricity that might harm
internal components.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Disconnect your computer and devices from their electrical outlets.
5
Also, disconnect any telephone or telecommunication lines from the
computer.
Disconnect the computer power cable from the wall outlet, and then
6
press the power button to ground the system board.
Open the computer cover (see page 84).
7