Dell Dimension K0004 Owner's Manual page 97

securing clips (2)
notches (2)
memory module
connector
cutouts (2)
step 5
step 6
Align the notches on the bottom of the module with the crossbar in
6
the connector.
NOTICE: To avoid damage to the memory module, press the module straight
down into the socket with equal force applied at each end of the module.
Insert the module straight down into the connector, ensuring that it
7
fits into the vertical guides at each end of the connector. Press firmly
on the ends of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the
cutouts at each end of the module.
Close the computer cover (see page 107).
8
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
9
them on.
Right-click the My Computer icon and then click Properties.
10
Click the General tab.
11
memory connectors
on system board
step 7
97
Adding Pa rts