Dell Dimension K0004 Owner's Manual page 102

102
A d d i n g Par ts
Connect a power cable to the drive.
12
NOTICE: Match the colored strip on the cable with pin 1 on the drive.
Locate the extra connector on the drive cable that is attached to your
13
first hard drive and attach the connector to the second hard drive.
Your computer uses cable-select drive cables. This means that the
device connected to the end connector of the drive cable is the master
device and the device connected to the middle connector is the slave
device. Be sure that the jumper setting on the new device is set for
"cable select" (see the documentation that came with the drive for
information).
power cable
Close the computer cover.
14
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
15
them on.
second hard-drive
cable (secondary
drive)
first hard-drive
cable (primary
boot drive)