Page 1
AC-EX150-BKT User Manual AC-EX150-BKT 150 m 1080p (100 m 4K) HDBaseT Extender w/ 4K60 support. Bi-DirecBonal PoE, IR, and RS232. Model Numbers: AC-EX150-BT ~ HDBaseT Transmi9er w/IR and RS-232 AC-EX150-BR ~ HDBaseT Receiver w/ IR and RS-232 Page 1...
AC-EX150-BKT Product Overview AVPro Edge presents the quick-deployment 4K HDBaseT Extender Set. This set can deliver 4K signals over Category cable up to 100 meters (330 S) and Full HD signals up to 150 meters (492S). The AC-EX150-BKT features field-criYcal features, including Bi-DirecYonal PoH (Power Over HDBaseT) and Bi-DirecYonal RS232 for control.
Change the resoluYon of the source device to 1080p or 4K/60Hz 4:2:0 Exchange HDMI cables between the Source and Transmi9er Use a 2-meter or longer HDMI cable. HDMI cables oSen fail to reliably sync in shorter lengths. Contact AVPro Edge Technical Support if these suggesYons do not work Page 6...
Page 7
Re-terminate connectors. Cable testers verify conYnuity but not signal integrity. A conYnuity tester is insufficient to determine if a cable will be capable of supporYng an HDBaseT signal. Contact AVPro Edge Technical Support if these suggesYons do not work. Page 7...
AC-EX150-BKT Functions & Setup of the Transmitter EDID Management With DIP switches on the bottom of the Transmitter The first 3 are used to set the EDID · ON/UP/1 · OFF/DOWN/0 EDID SETTINGS JUMPER BYPASS (HDBT) 1080P_2CH 1080P_8CH 4K 60Hz YC420_3D_2CH...
Change the resoluYon of the source device to 1080p or 4K/60Hz 4:2:0 Exchange HDMI cables between Source and Receiver Use a 2-meter or longer HDMI cable. HDMI cables oSen fail to reliably sync in shorter lengths. Contact AVPro Edge Technical Support if these suggesYons do not work Page 9...
Re-terminate connectors. Cable testers verify conYnuity but not signal integrity. A conYnuity tester is insufficient to determine if a cable will be capable of supporYng an HDBaseT signal. Contact AVPro Edge Technical Support if these suggesYons do not work. RS-232 Configura>on RS-232 can be used to pass control signals bidirecYonally to and from RS-232-compaYble devices.
From Rack (Using an IR sensor): Plug the IR receiver sensor into the IR IN on the AC- EX150-BKT transmi9er to pass infrared signals generated from a device or IR Remote. From Remote End: Use an IR-receiver sensor on the AC-EX150-BKT receiver (IR In Port) to send IR signals back to the rack and out of the TRANSMITTER IR Out Port with an emi9er.
Page 12
AC-EX150-BKT *NOTE: For best results, only use the provided IR sensors and emiZers IR Connections to AC-EX150-BKT (Transmitter) ■ IR INPUT (IR SENSOR) IR OUTPUT (IR EMITTER) IR Connections to AC-EX150-BKT (Receiver) ■ IR INPUT IR OUTPUT (RECEIVER SENSOR) (IR EMITTER)
AC-EX150-BKT Troubleshoo>ng Verify Power • Verify ConnecYons - Check that all cables are properly connected • TX Indicator TroubleshooYng Lights • RX Indicator TroubleshooYng Lights • IR Issues - Verify correct connecYons • o Flashing Emi9ers may not funcYon properly. Use the IR emi9ers supplied with the...
AC-EX150-BKT Maintenance To ensure reliable operaYon of this product as well as protecYng the safety of any person using or handling this device while powered, please observe the following instrucYons. Use the power supplies provided. If an alternate supply is required, check voltage, •...
AC-EX150-BKT Warranty If your product does not work properly because of a defect in materials or workmanship, AVProEdge (referred to as “the warrantor”) will, for the length of the period indicated as below, (Parts/ Labor (10) Years), which starts with the date of original purchase (“Limited Warranty period”), at its opYon either (a) repair your product with new or...
Page 18
AC-EX150-BKT Thank you for choosing AVProEdge! Please contact us with any ques=ons, we are happily at your service! AVPro Edge 2222 E 52nd St N ~ Sioux Falls, SD 57104 1-877-886-5112 ~ 605-274-6055 support@avproedge.com Page 18...
Need help?
Do you have a question about the AC-EX150-BKT and is the answer not in the manual?
Questions and answers