Icom IC-03AT Instruction Manual page 45

4. Мо or low power out-
put.
5. No modulation (when
using an external
microphone).
6. PROGRAMMED SCAN
does not function.
7. All key functions are
disabled.
du Qu UU
eRF POWER OUTPUT SELEC-
TOR SWITCH is in the [LOW]
position.
e The battery pack is exhausted.
eThe antenna feedline is cut or
shorted (when using an external
antenna). Е
eBad connection of the тісго-
phone plug.
eThe transceiver is in MEMORY
MODE.
eThe frequencies memorized in M5
and M6 are the same, or their
difference is less than the fre-
quency step rate.
е The LOCK FUNCTION is engaged.
e The CALL FUNCTION is engaged.
is
eSet the RF POWER OUTPU
SELECTOR SWITCH to [HIGH]
position.
e Replace the battery pack with a
new one or recharge it.
eCheck the antenna feedline and
correct any problems.
eCheck the connection of the
microphone plug and correct any
problems.
ePush the [A]/[CL] key to set in
DIAL MODE.
e Memorize frequencies with a larger
step rate than those currently set
in М5 and M6.
eClear the LOCK FUNCTION by
pressing IN the [FUNC] SWITCH
and pushing the [D] /[LOCK] key.
eClear the CALL FUNCTION by
pushing the [A] /[CL] key.
ud =