Icom IC-03AT Instruction Manual page 35

(2) PROGRAMMED SCAN
1) Store the frequencies of the upper and lower limits of the desired
scan range into either M5 or M6.
2) Set the ІС-ОЗАТ іп DIAL MODE by pushing the [A] /[CL] key if
the transceiver is in MEMORY MODE.
3) Adjust the [SQUELCH] CONTROL to quiet the noise output
from the speaker.
4) Push and hold the [FUNC] SWITCH and push the [С] /[PS] key.
The scan starts from the frequency memorized in M5 and moves
towards the frequency memorized in M6. |
ө The scanning frequency increments depend on the frequency
step rate setting. See page 21.
5) Any signal which opens the squelch when it is engaged stops the
scan automatically and the transceiver locks onto the frequency.
6) To clear the scan function, push the [А] /[CL] KEY or [PTT]
SWITCH to revert to the transmit mode.
e The scan stops on the frequency displayed.
e "S" disappears on the FREQUENCY DISPLAY.