Audiovox LCM1041TV Owner's Manual page 12

Auxiliary A/V Stereo Inputs Jack
The LCM1041TV may be equipped with an auxiliary A/V stereo input connector (optional).
These inputs are provided to facilitate the temporary connection of optional audio/video equipment, such
as a camcorder or video game system. To play a source with these inputs, an RCA patch cord is
required to connect the audio/video signals to their respective jacks. Mono audio sources will require
the use of an RCA Y-cable (P/N 0892165) to connect to both right and left inputs. If patch cords are
installed into the AUX inputs, the AUX INPUT 2 will be temporarily bypassed. Once the connections
have been made, turn the LCM1041TV on and press the source button on the LCM1041TV or the
TV/Video button on the remote control until "Video 2" is displayed on the screen. The unit will now play
the audio and video signals from the accessory connected. The remote control will not operate the
accessory components.
Wired FM Modulator (P/N 0190730)
Your video system may be equipped with an RF modulator, that allows you to listen to the LCM1041TV's
audio signal by tuning your vehicle's radio to the selected frequency, (88.7 or 89.1- check with your
installer) and tuning on the remote mounted RF modulator switch. (In most cases this toggle switch will
be located underneath the driver's side of the dash, check with your installer for the exact location.)
Whenever the RF modulator is on, broadcast radio reception will be poor. Turning the remote mounted
toggle switch off will allow for normal radio reception.
Video Output
The LCM1041TV provides a video output for an optional video monitor(s). This output will provide a
video signal that duplicates the signal displayed by the LCM1041TV to an additional monitor or video
display. Please see your installer for more information.