Table of Contents
Advertisement
68
Adding Parts
CAUTION:
Some network adapters automatically start the
computer when they are connected to a network. To guard against
electrical shock, be sure to unplug your computer from its
electrical outlet before installing any cards.
Insert the card into the card connector.
10
If the card is full-length, insert the end of the card into the card guide
bracket as you lower the card toward its connector on the system
board. Insert the card firmly into the card connector on the riser board.
Lower the retention arm and press it into place, securing the card(s) in
11
the computer.
Replace the card cage.
12
a
Align the tabs in the side of the card cage with the slots on the side
of the computer, and slide the card cage down into place.
b
Make sure that the riser board is fully seated in the connector on
the system board.
card cage
Reconnect any cables that you removed in step 6.
13
Connect any cables that should be attached to the card.
14
See the documentation for the card for information about the card's
cable connections.
tabs (2)
slots (2)
Advertisement
Table of Contents
