Figure 3-7. Removing and Installing a Power Supply
1
power supply handle
3
release latch
Replacing a Power Supply
1 On a system with redundant power supplies, verify that both power
supplies are the same type and have the same maximum output power.
NOTE:
supply label.
2 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-7.
NOTE:
procedure, relatch it. For information about the cable management arm, see
the system's rack documentation.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION:
When connecting the power cable, secure the cable with the Velcro
strap.
The maximum output power (shown in watts) is listed on the power
If you unlatched the cable management arm in step 2 of the previous
3
2
Velcro strap
Installing System Components
1
2
87