Replacing The Riser 2 Board On The Expansion-Card Bracket - Dell PowerEdge R710 Series Hardware Owner's Manual

Figure 3-29. Removing and Replacing the Riser 2 Board
1
1 expansion-card bracket
3 tab slot (4)
5 screw
5 Remove the expansion-card riser board:
Using a Phillips screwdriver, remove the securing screw from the
a
assembly. See Figure 3-29.
Slide the riser board off of the four securing tab hooks.
b
Lift the riser board from the bracket.
c

Replacing the Riser 2 Board on the Expansion-Card Bracket

1 Place the riser board in the expansion-card bracket so that the four tab
hooks are fully inserted through the tab slots on the riser board. See
Figure 3-29.
2 Slide the riser board into the tab hooks.
3 Using a Phillips screwdriver, secure the board with the Phillips screw.
128
Installing System Components
2
2 tab hook (4)
4 riser 2 board
3
4
5