Dell PowerEdge R710 Series Hardware Owner's Manual page 142

5 Remove the system battery.
Support the battery connector by pressing down firmly on the positive
a
side of the connector.
Press the battery toward the positive side of the connector and lift it
b
up out of the securing tabs at the negative side of the connector.
Figure 3-33. Replacing the System Battery
1 positive side of battery connector
3 negative side of battery connector
6 Install the new system battery.
Support the battery connector by pressing down firmly on the positive
a
side of the connector.
Hold the battery with the "+" facing up, and slide it under the
b
securing tabs at the positive side of the connector.
Press the battery straight down into the connector until it snaps into
c
place.
7 Replace the fan bracket. See "Replacing the Fan Bracket."
8 Close the system. See "Closing the System."
9 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
10 Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program."
142
Installing System Components
1
3
2
2
system battery