Silvercrest SFT 88 Manual page 52

You can delete all basic settings stored on the device by taking the
batteries out of it. Saved measurements will still be stored.
56 GB/IE
452667_2310_V5.0_silv_Infrarot-Thermometer_Content_OS.indd 56 452667_2310_V5.0_silv_Infrarot-Thermometer_Content_OS.indd 56
Press the memory button
pressed, the display shows previous measurements taken, which
are consecutively numbered from 1 to 30. The most recent meas-
urement is labelled with the number 1 and the oldest has the num-
ber 30.
The user can press the measurement button
measurements. The device automatically switches off after 60 seconds.
Restoring the device to its factory settings
Cleaning and care
ATTENTION!
Possible property damage! Never hold the product under water
as liquid could enter the product and damage it.
The measurement sensor
to ensure accurate measurements. Accuracy of temperature meas-
urements can be impaired by damage to the measurement sensor
or the presence of dirt, fingerprints, dust and other contaminants
on the measurement sensor
can impair the performance or cause other issues.
Never immerse the thermometer directly in water.
The measurement sensor
mometer. Wipe the measurement sensor
with a soft cloth that is slightly dampened with 75% isopropyl al-
cohol solution. Do not use abrasive cleaning agents. Leave the ap-
pliance to dry for at least 10 minutes before taking temperatures.
Note: Only use isopropyl alcohol to clean the measurement
sensor .
7
. Every time the memory button
1
4
must always be dry, clean and intact
7
. Damaged measurement sensors
7
is the most sensitive part of the ther-
7
and the thermometer
7
is
1
to carry out new
7
7
09.04.24 06:59 09.04.24 06:59