Silvercrest SFT 88 Manual page 51

The device saves the measured values of the last 30 measurements
automatically. The date, time, and mode are saved with each measure-
ment. If the 30 memory spaces have been exceeded, the respective
oldest measured value will be deleted.
The saved measured values can be requested as follows:
452667_2310_V5.0_silv_Infrarot-Thermometer_Content_OS.indd 55 452667_2310_V5.0_silv_Infrarot-Thermometer_Content_OS.indd 55
from 38.0 °C (100.4 °F) = red
If the temperature is in the fever range (red display) then a fever
alarm is activated (10 beeps).
The device automatically switches off after 60 seconds.
Clean the device after every use as described in the chapter
"Cleaning and care".
Measuring the temperature of objects
Press the measurement button
Press the mode button
mode. After switching over to the
measure the temperature of an object.
Point the thermometer towards the middle of the object or liquid
that is to be measured (never immerse in liquids!) at a distance of
less than 5cm, then press the measurement button
The measured value appears on the display
measuring process is indicated by a short beep (if sound is activated).
The device automatically switches off after 60 seconds.
Clean the device after every use as described in the chapter
"Cleaning and care".
Please note that the displayed temperature is the temperature which
has been determined and is not the adjusted surface temperature.
It cannot be compared with the forehead temperature.
Displaying saved measured values
Press the measurement button
to switch on the thermometer.
4
to switch between forehead and object
5
measurement mode, you can
to switch on the thermometer.
4
.
4
and the end of the
3
GB/IE 55
09.04.24 06:59 09.04.24 06:59