Replacing The Battery - NEC VERSA DOCK Manual

Replacing the Battery

A Lithium Ion (Li-Ion) battery in the NEC Versa Dock maintains the
system configuration for the last system docked. If the NEC Versa Dock
fails to maintain the system configuration information, you may need to
replace the battery.
The battery is located below the left IDE file bay. Replace the battery in
the NEC Versa Dock as follows.
1. Undock and remove the NEC Versa from the NEC Versa Dock.
2. Unplug any peripheral devices and cables attached to the NEC Versa
Dock, including the power cable.
3. Remove the docking tray, front panel,and cable cover. See the
instructions in Chapter 4, "Removing Trays, Panels, and Covers" for
details.
4. Remove the screw that secures the left IDE bracket and slide the
bracket out of the NEC Versa Dock.
5. Locate the battery bay below the left IDE file bay. The battery rests
on the bottom plate of the NEC Versa Dock.
5-4 Solving Problems
Note: If you have an IDE device installed in the
file bay, you must disconnect the cables from the
motherboard and remove the device. Refer to
Chapter 4, "Installing Devices in the File Bays" for
instructions.