Connecting The Power Cable - NEC VERSA DOCK Manual

Getting your NEC Versa Dock up and running is easy. This chapter
provides the procedures you need to get started. They include:
!
Connecting the power cable to AC power and to the NEC Versa
Dock.
!
Preparing the NEC Versa for docking and docking it on the NEC
Versa Dock.
!
Powering on the NEC Versa.
This chapter also describes normal and emergency undocking when you
want to use the NEC Versa by itself.

Connecting the Power Cable

Follow the instructions given next in the order presented to get your
NEC Versa and NEC Versa Dock up and running.
The power cable that came with the NEC Versa Dock provides power to
both the NEC Versa Dock and the NEC Versa when docked.
2-2 Docking and Undocking
Note: Connect the AC power cable to the NEC
Versa Dock and AC power before docking the
computer.
Note: If you need to replace the NEC Versa
Dock power cable, make sure it meets the following
specifications:
!
In North America, the cable should be rated for
120 V, 7 A. The plug is a NEMA 5-15P. Use an
SVT or SJT 18/3 AWG cable that is less than 15
feet (4.5 m) long. Use connector type IEC320.
!
In Europe, the cable should be rated for 230 V
(220-240 V), 10 A. The plug is country-specific.
Use an H05VV-F or H05VVH2-F cable that is
less than 15 feet (4.5 m) long. The connector
type is EN60320.