NEC VERSA DOCK Manual page 65

4. Slide the rear part of the docking tray towards the back of the NEC
Versa Dock until it is seated properly.
aligned with the hole in the docking tray as you slide
the docking tray into place.
5. You are now ready to replace the front panel. If the device(s) you
installed require(s) external access, remove the appropriate file bay
cover(s) on the front panel by squeezing the two inside tabs together
and gently pushing the bay cover out of the front panel.
A - Bay cover tabs (2)
6. Replace the front panel on the NEC Versa Dock by aligning the four
tabs at the top then replacing the two bottom screws.
Note: Make sure the docking connector is
NEC Versa Dock file bay covers
Installing Options and Connecting Devices 4-19