Replacing The Battery - NEC VERSA MINIDOCK 6000 Manual

T
The power went out and you need to undock the NEC Versa.
T
While trying to record using the microphone, excessive noise is emanat-
ing from the speakers.
T
When docked, your NEC Versa does not work as it did when docked
previously and the settings seem to have changed.
T
When docking, you receive a CMOS error.

Replacing the Battery

A Lithium (Li) battery in the MiniDock maintains system configuration in-
formation for the last system docked. If the MiniDock fails to maintain the
system configuration information, you may need to replace the battery.
Replace the battery in the MiniDock as follows:
Undock and remove the NEC Versa from the MiniDock.
1.
Unplug any peripheral devices and cables attached to the MiniDock, in-
2.
cluding the power cable.
5-2 Solving Problems
Undock the NEC Versa manually while power is still off by pressing
on the Eject lever.
Try moving the speakers away from the MiniDock.
Try adjusting the volume with the volume control knob. If that
doesn't work, open the Audio Applications in Windows and adjust
the volume control with the slide bar. You can also try adjusting the
Mic control in the Mixer.
Reboot your system, go into the NEC Versa Setup utility, and reset
the parameters. If another system is docked on the MiniDock, the
new system parameters overwrite the original system parameters in
MiniDock memory.
The battery in the MiniDock may need to be replaced. See
"Replacing the Battery" for instructions.
Switching between NEC Versa types may cause a one-time CMOS
error. Reboot your system, go into the NEC Versa Setup utility, and
reset to the default configuration settings to correct the problem.