I/O Board; Heat Shield, Sound Board, Microphone Assembly - NEC VERSA 6000 Series Service Manual

4-18 Field Service Guidelines
2. Remove the two screws that secure the heat shield to the base unit and lift up the
heat shield.
3. After removing the heat shield, lift the sound board from connectors P1 and P2 on
the I/O board.
To remove the microphone assembly, locate the cable attached to the assembly.
4.
Disconnect the cable from CN4 on the I/O board and lift the microphone assembly
5.
out of the base unit.
Figure 4-14 Heat Shield, Sound Board, Microphone Assembly

I/O Board

Remove the I/O board as follows.
Remove the following as previously described:
1.
LCD
top cover
keyboard
LCD status bar
VersaGlide
metal keyboard support