Dog trace d-control 600 Manual page 39

Place the test discharge lamp in contact with each of the
contact points – loosen the contact points, insert the lamp's
outlets under the contact points so they are in the touch with
the screw and tighten them (see picture).
Turn ON the transmitter and the receiver.
Select stimulation function button.
The test discharge lamp will increase a light intensity when
increasing stimulation level.
6. If the problem still persists, contact the dealer.
Maintenance
It is important to keep the device clean. Never use volatile substances eg.: thinner, gasoline or
other cleaners. To clean your d-control use a soft, damp cloth and neutral detergent if necessary.
Receiver (collar) is water proof only on condition of the good state of the seal. We
recommend you to replace the rubber seal, which is placed under the cover of the battery
compartment of the receiver, once a year. Clean the rubber seal and make sure that the rubber
seal is correctly seated in its groove every time you change the batteries; tighten the screws using
adequate power. If the device is not used for a longer time, take out the batteries from the battery
compartment.
Showing test lamp attachment
39