Dog trace d-control 600 Manual page 32

The transmitter is made for training of two dogs, so you can pair it with two receivers. Use the
buttons / to choose the right dog.
IMPORTANT: Before programming is started make sure that no one else uses his/her
d-control in your neighbourhood. Your receiver could randomly receive the code from
another transmitter and get paired with it. If this happens, program your receiver once again,
using your transmitter.
Pairing of the button
1. Turn ON your transmitter.
2. The receiver has to be turned OFF.
3. Press the button
4. Move the lower part of the transmitter to the target on your receiver (see the Fig. on page 31)
and hold in position so the green LED is steadily lit. After approximately 5 seconds it will switch
to the pairing /programming mode, indicated by flashing of the red and green LED at the
same time (4x).
5. Then take your transmitter away from the receiver and press down the audible beep tone
button on your transmitter. If you hear the beep tone the pairing has been successful.
Pairing of the button
Press the button
above (this can be followed when you use d-control 600, 1000 or 1600 with a new purchased
receiver or when you purchased d-control 602, 1002 or 1602).
Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint using the same transmitter or
another (see the section Programming (pairing) of the transmitter and the receiver).
TIP: It is possible to program an unlimited number of receivers to a one transmitter.
Example: Button
set all 3 in pairing regime and then press button for audible beep tone. All these receivers will
32
with the first receiver
for the first receiver choice.
with the second receiver
for the second receiver choice and follow the steps as for the first receiver
is paired with 3 receivers, they can be programmed one by one or we can