Removing The System Unit Cover - NEC POWERMATE VE - 03-1996 Manual

Always hold a chip or board by its edges. Avoid
touching the components on the chip or board.
Take care when connecting or disconnecting cables. A
damaged cable can cause a short in the electrical circuit.
Misaligned connector pins can cause damage to system
components at power-on.
When installing a cable, route the cable so it is not
pinched by other components and is out of the path of
the system unit cover. Prevent damage to the connectors
by aligning connector pins before you connect the cable.
When disconnecting a cable, always pull on the cable
connector or strain-relief loop, not on the cable.

Removing the System Unit Cover

The following procedure describes how to remove the
system unit cover.
Before removing the system unit cover, turn off the
power and unplug the system power cable. Power is
removed only when the power cable is unplugged.
Turn off and unplug the system unit.
1.
2. Disconnect the keyboard, mouse, monitor, and any other
external options (such as a printer) from the rear of the
system unit.
!
WARNING
Installing Options 3-5