Installation - NEC DSX CORDLESS LITE II Manual

Installation

Installing the Base
Installation
Installing the Base
Connecting the Base
To connect the base to the DSX system (Figure 2: Installing the Base) :
Be sure to review Guidelines for Placing the Base, Figure 3: Correct Installation Methods, and Figure 4:
Incorrect Installation Methods prior to connecting the base unit to the system.
1. Install a modular jack within 6 feet of the base and within 6 feet of an available standard (NEMA 5-15R)
120 VAC outlet.
2. Run a single pair of 24 AWG station cable from an available 16ESIU PCB digital station port on a sta-
tion block to the modular jack.
3. Terminate the station cable WHT/BLU - BLU/WHT leads to the RED and GRN lugs on the modular jack.
4. Plug one end of a modular line cord into the base LINE IN jack; plug the other end of the line cord into
the modular jack.
5. (Optional) Plug an accompanying DSX keyset into the LINE OUT jack in the base.
- While the keyset and the cordless handset are idle, you can press Cordless and Desk on the base
To connect the AC Adaptor to the base:
1. Run the AC adaptor cord under the strain relief on the back of the base as shown.
2. Plug the AC adaptor into AC outlet.
3. Be sure the base antenna is in the vertical position.
Checking the Base LEDs
Normal Operation when the cordless handset is operational
❥ When the cordless handset is operational, the Power and Cordless LEDs are on.
❥ When the keyset is operational, the Power and Desk LEDs are on.
Troubleshooting
❥ If the Power LED is off, the base power supply is not properly connected.
1. For best results, the base unit should be placed in line-of-site with its handset.
2. Cordless telephone range and reception can vary from site to site. Some of the things that may
adversely affect range and reception are:
• Placing the base against or close to a wall (particularly if the wall has metal studs).
• Positioning the base close to a device that emits Electromagnetic Interference (EMI), such as a TV,
radio, computer, fluorescent light, fax machine, or printer.
• Installing the base close to other 900 Mhz devices, such as Symbol or Telex hand-held inventory
devices.
• Installing the base above a ceiling that uses foil-backed insulation.
• Installing the base behind a door which can be closed, tinted windows, or one-way glass which will
separate the base from the handset.
3. Always raise the base unit antenna to its full vertical position.
4. When installing more than one cordless in the same site:
• Be sure the base units are at least 15 feet apart.
5. After installation, change each telephone's channel by pressing CH on the handset. This will minimize
interference between your cordless telephones.
4 ◆ Chapter 1: Installation
to activate either phone (and deactivate the other).
Guidelines for Placing the Base
DSX Cordless Lite II Telephone User Guide