Installing The Switch; Selecting A Site - SMC Networks SMCGS10P-SMART Installation Manual

3
I
This chapter describes how to install the switch.
S
ELECTING A
The site should:
◆
be at the center of all the devices you want to link and near a power
■
outlet.
be able to maintain its temperature within 0 to 50 °C (32 to 122 °F)
■
and its humidity within 10% to 90%, non-condensing
provide adequate space (approximately two inches) on all sides for
■
proper air flow
be accessible for installing, cabling and maintaining the devices
■
allow the status LEDs to be clearly visible
■
Make sure twisted-pair cable is always routed away from power lines,
◆
fluorescent lighting fixtures and other sources of electrical interference,
such as radios and transmitters.
Make sure that the unit is connected to a separate grounded power outlet
◆
that provides 100 to 240 VAC, 50 to 60 Hz, is within 2 m (6.6 feet) of each
device and is powered from an independent circuit breaker. As with any
equipment, using a filter or surge suppressor is recommended.
NSTALLING THE
S
ITE
S
WITCH
– 36 –