TOOLS REQUIRED
•
Scissors or utility knife
•
Isopropyl alcohol
•
1/2" Wrench or socket
•
Phillips screwdriver
•
5/8" Drill bit & drill
PARTS INCLUDED IN THE BOX
1x Passenger side rail
A
1x Passenger side add-on rail
B
1x Driver side rail
C
1x Driver side add-on rail
D
1x Hard fold cover
E
1x Bulkhead seal
F
2x Cover retainer clamps
G
6x Clamps for side rails
H
2x Buckle ends
I
4x Screws
J
6x Clamps for add-on rails
K
2x Drain tubes
L
12x Rubber filler strips
M
(3 sets of 3 different sizes included)
1
If a bulkhead seal (F) was
received a bulkhead seal (F) with the cover (E), clean the top of the bulkhead
with soap and water to remove dirt and debris. Clean the area with isopropyl
alcohol to remove wax or grease and to evaporate any remaining water. Allow
the surface to dry. Peel the backing and adhere the seal from one bulkhead edge
to the other. Remove any excess with scissors or a utility knife. Apply pressure
evenly to the entire seal to ensure proper adhesion. If the truck has a drop-in
bedliner, no seal will be needed.
RealTruck UnderCover • 59 Absolute Dr., Rogersville, MO 65742 • 866-900-8800 ©RealTruck Group, Inc., 2025
NOTE: It is important that all areas where
the bed cover mounts are clean and free
of debris prior to installing.
E
D
(on select make/models)
NOT
included in your kit, skip to step 2. If you
INTERNATIONAL
FLEX
INSTALLATION SHEET
Any damaged or missing parts?
Parts will be shipped to you directly.
Call 866-900-8800 Mon - Fri 8:00 am - 5:00 pm CST
or email info@undercoverinfo.com
I
G
J
H
K
C
F
ULTRA FLEX
ARMORFLEX
l
l
B
A
L
F
M
G
H
I
L
Cab
J
K
M
Part# FX101419_Install Rev. 1-2-25
Need help?
Do you have a question about the UNDERCOVER FLEX and is the answer not in the manual?
Questions and answers