Ruijie RG-RAP73Pro Installation Manual page 16

Installation Guide

Make sure that the AP is powered off when you cut off the power supply.

Do not place the AP in a wet position, and keep it away from liquid.

Keep the AP far away from grounding or lightning protection devices for power equipment.

Keep the AP away from radio stations, radar stations, high-frequency and high-current devices, microwave
ovens, and other high-power wireless devices.
2.1.4 Laser Safety
The RG-RAP73Pro supports optical transceiver modules. It is a Class I laser product.
Precautions:

When an optical transceiver is working, ensure that its port is connected to an optical cable or covered by a
dust cap to keep out dust and prevent it from burning your eyes.

Do not stare at any optical port.
Warning
Do not approach or look into any optical port under any circumstances. This may cause permanent damage to
your eyes.
2.2 Installation Site Requirements
The RG-RAP73Pro must be used indoors. For normal operation and prolonged service life of the access point,
the installation site must meet the following requirements.
2.2.1 Bearing
Ensure that the installation site is firm enough to support the weight of the RG-RAP73Pro and its accessories.
2.2.2 Space

The AP should be installed in an open environment if possible. If the AP is to be installed in an enclosed
environment, ensure that a good ventilation and heat dissipation system is available.

Ensure that the installation site has sufficient space for heat dissipation.
2.2.3 Ventilation
The RG-RAP73Pro adopts natural cooling. When installing the AP, ensure that there is sufficient space in front,
back, left, and right of the AP for heat dissipation.
2.2.4 Temperature and Humidity
To ensure that the RG-RAP73Pro works properly and has a long service life, maintain a proper temperature and
humidity in the working environment. Improper room temperature and humidity can cause damage to the AP.

High relative humidity may affect insulation materials, resulting in poor insulation and even electrical leakage.
Sometimes it may lead to changes in the mechanical properties of materials and corrosion of metal parts.

Low relative humidity can dry and shrink insulation sheets and cause static electricity that can damage the
circuitry.

High temperatures greatly reduce device reliability and shorten service life.
9
Preparing for Installation