Table of Contents 1. Verify the Contents Inside the Package Box .............3 2. Basic Operation ..................... 4 3. Basic System Configurations ................5 4. Logging in to Web screen ................6 5. Logging on to Console ................... 7 6. Installation Check ..................8 Further Information ...................
1. Verify the Contents Inside the Package Box The package should contain one of PLANET SIP VoIP Gateway series and the items shown below: Model Package Description z Quick Installation Guide x 1 z Power Adapter x 1 VGW-420FS/420FO VGW-820FS/820FO z RJ11 Cable x 1 z RJ45 Cable x 1...
2. Basic Operation PLANET VGW SIP VoIP Gateway series supports basic operation through a standard analog phone set. With an analog phone set, the users can dial the service codes to maintain their gateway. The service code list is shown below: Service Code Operation Notice *158# Check LAN port IP address *159# Check WAN port IP address *114# Check port account *115# Check port group account *160*1# Enable Web access through WAN port Restore to factory default values of Web login Username/ *165*000000# Password and WAN/LAN port IP addresses *166*000000# Restore to default factory settings *111# Restart device...
3. Basic System Configurations The VGW series is easy to install by following the steps below. Step 1: Connect a computer to a LAN port on the VGW series. Your PC must be set to 192.168.0.X, the same domain as that of the VGW series. Step 2: Start a web browser. To use the user interface, you need a PC with Google Chrome, Microsoft Edge or Mozilla Firefox. Step 3: Enter the default IP address of the VGW series: http://192.168.0.1 into the URL address box. Default WAN IP 172.16.0.1 Default Subnet Mask...
4. Logging in to Web screen z Enter the default user name admin and the default z password admin and then click Login to enter Web-based user interface. z After logging in, you will be prompted to change the initial password to a perma- nent one. z The password must contain 8-18 characters, including upper case, lower case, numerals, and other symbols. Please note spaces (blanks) are not accepted.
5. Logging on to Console z Enter the default user name admin and the default z password admin@123#. z After logging in, you will be prompted to change the initial password to a perma- nent one. z The password must contain 8-18 characters, including upper case, lower case, numerals, and other symbols. Please note, spaces (blanks) are not accepted.
6. Installation Check Before the unit’s power is on, make sure the cable connection, power connection, etc. are in place. The following steps are to be referred: z Turn the device’s power on, and check whether the power indicator (PWR) is on or not. If not, check the connection of the power plug or power adaptor. z Check Ethernet port (WAN/LAN) LED status. When the port LED is blinking, it indicates that the network is activated. Otherwise, check the network connection.
Need help?
Do you have a question about the VGW Series and is the answer not in the manual?
Questions and answers