Important Safety Instructions - activTek INDUCT 2000+ OZONE Manual

IMPORTANT SAFETY INSTRUCTIONS

WARNING
CAUTION
Read this manual in its entirety before using your activTek Induct 750
Induct 2000 Ozone.
+
Keep out of the reach of children.
•
Live voltage may be present
•
Disconnect power at the breaker or fuse panel before servicing unit; always follow OSHA lockout
procedures to prevent accidental exposure to electrical energy
•
If installed near a furnace or where emergency heat coils could raise the temperature inside the plenum,
cycle the AC unit through the heating cycles assuring that the temperature never exceeds
200 F (93 C); the activTek
° °
•
If the unit is hard wired, be sure the power to the unit is off; always follow OSHA electrical lockout safety
requirements to prevent accidental release of energy during service or maintenance activities
•
Never attempt to check operation of the activTek
can result; use the indicator lamps on the bottom of the ballast only
•
UV Light in operation; DO NOT operate unless the unit is completely and
correctly assembled; failure to follow warnings may result in severe eye
damage and electrical shock
•
To prevent damage to the unit, operating environment temperature must
never exceed 200
•
To reduce the risk of electric shock, this equipment may have a grounding
type plug that has a third (grounding) pin; this plug will only fit into a
grounding type power outlet; if the plug does not fit into the outlet, contact
qualified personnel to install the proper outlet; DO NOT alter the plug in
any way
•
This unit is equipped with a universal ballast that operates at nominal
voltages between 120 and 240 VAC, 50/60 Hz
•
To Reduce the Risk of Electric Shock – DO NOT use in wet or damp
locations; this equipment emits UV-C radiation; DO NOT locate
equipment in any location allowing direct line-of-sight to vents, returns, or
other duct openings
•
DO NOT use this unit with an extension cord
•
Wiring and installation of this unit must be done by a licensed HVAC
contractor or electrician; failure to do so will void warranty of the product
•
When the unit is installed in a roof mounted HVAC system, the unit must be
protected from the elements
•
The activTek Induct 750
power 24/7; DO NOT install where power to the unit will be cycled on and off
Location for Protective Earth Line.
Cell Assembly must not exceed 200
®
SAVE THESE INSTRUCTIONS
F (93 C)
o o
Ozone and activTek Induct 2000
+
F (93
°
Cell Assembly by direct observation; severe eye damage
®
Ozone require
+
Ozone or activTek
+
C)
°
3