Assa Abloy Corbin Russwin SN200 Wiegand Installation Instructions Manual page 25

SN200 Wiegand SN210 OSDP
ED5000 Series Exit Device
Installation Instructions
6. Install Door (continued)
Install Inside Escutcheon
Note
: Check electrical connections.
1. Feed excess ElectroLynx wire harness back into door.
2. Feed excess trim and exit device harnesses under head cover.
3. Install inside escutcheon using (2) #8-32 x 5/8" oval head screws (Figure 15a).
Note
: Be careful not to pinch wires between escutcheon and door surface.
Neatly fold wires onto themselves and into the
remaining space to prevent pinching wires when
mounting escutcheon.
Configuration for SVR
Figure 15b
1-800-810-9473 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2020 - 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 15a
25
Configuration for Rim/
CVR/Mortise
FM563 11/2024