Assa Abloy Corbin Russwin SN200 Wiegand Installation Instructions Manual page 21

SN200 Wiegand SN210 OSDP
ED5000 Series Exit Device
Installation Instructions
6. Install Door (continued)
Install Exit Device/ Head Cover
Install Exit Device
Note
: To install the Exit Device, follow instructions packed with device to secure device to door.
Install Head Cover
1. Lay wire device harnesses across ¾" hole (Figure 11a).
2. Tuck wires into hole when installing cover so that wires are not pinched between head cover and door.
3. Attach head cover using (2) #8-32 flat head screws (Figure 11b).
Figure 11a
1-800-810-9473 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2020 - 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Use ¾" hole to tuck trim
and device wire harness
under head cover
21
Figure 11b
FM563 11/2024