Assa Abloy Corbin Russwin SN200 Wiegand Installation Instructions Manual page 23

SN200 Wiegand SN210 OSDP
ED5000 Series Exit Device
Installation Instructions
6. Install Door (continued)
Connector Attachments
1. Connect 6-pin connector from exit device to 6-pin connector on reader harness (Figure 13a, 13b).
2. Connect 2-pin connector from exit device to 2-pin connector on reader harness (Figure 13a, 13b).
Note: For the following refer to page 9 for ElectroLynx door harness and lock interface.
Do not offset connectors and be sure they are completely seated.
3. Connect ElectroLynx 4- and 8-pin connectors from the door harness to (black) 4- and 8-pin connectors of the reader
harness (Figure 13c).
4. Carefully tuck connected harnesses into one-inch hole in door.
Note: Neatly fold the wires into the remaining space to prevent pinching wires when mounting inside escutcheon.
Reader
Harness
1-800-810-9473 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2020 - 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 13a
Figure 13c
Figure 13b
8-pin ElectroLynx
4-pin ElectroLynx
23
FM563 11/2024